Introducing our vehicle specific leveling system. Designed for specific vehicles and their leveling system application (cylinder size, frame & ride height, etc.) Quick, one touch operation that automatically deploys the jacks to bring the front level with the rear and stabilizes the entire vehicle in just over 30 seconds! On the fly manual adjustment feature that allows you to quickly operate each cylinder individually or in pairs. All-Up safety feature signals if one or more of the cylinders are not fully retracted before you drive off. Four powder coated cylinders made at our facility rated to lift 8,000 pounds per cylinder. One weatherproof hydraulic power unit with an American made marine pump & motor wrapped in a steel housing, allows the unit to be mounted outside in the elements so it does not take up storage space. 100 square inch "Bigfoot" pads for secure ground contact during operation. All necessary components and hardware for a complete installation! *This system does not have an inclinometer and does not read a level plane like the Bigfoot Automatic Leveling System.
Attention: Vehicles 5 years old or older, Measurement Required: Underneath the cab driver's area, locate the control arm mounting bracket for the front axle, just rearward of this bracket measure from the bottom of the vehicle frame to the ground (parked on level surface). If this measurement is below 15" use the Ford E-350 part numbers as they have a shorter front cylinder for better ground clearance. If this is not done, the cylinders may be swapped out in the installation process time frame (fee applied).
Increase your systems lift height & footpad diameter with a set of SnapPads! (#M27807-4)
Need to extend your Hydraulic Hoses? Call and order a Hydraulic Hose Extension Kit! (#M52190)